Komatsu — OPERATIONS AND CHECKS AFTER STARTING ENGINE

. OPERATION OPERATION position between low RAISE position, then equipment is not properly response of the work light load until engine (2) is within the green 3 - 103 IN COLD A REAS IC WARMING-UP OPERATION) e is equipped with an automatic warming-up device. (AUTOMAT IC WARMING-UP OPERATI This machin e is equipped with an autom When the en gine is started, if the engine c oolant temperature is low (below 30 °C (86 °F)), t he warming-up operation is carried ou t automatically. atic warming-up operation i s canceled if the engine coolant temperature reaches the specified The autom temperature (30 °C (86 °F)) or if the warming-up operation is continued for 10 minutes.

If the engine coolant or hydraulic oil temperature are low after the automatic warming-up operation, warm the engine up llows. arming-up operation is continued for 10 minut es. If the engine coolant temperature further as fo 1. Turn fue l control dial (1) to the cent idling (M at a mid IN) and high idling (MAX) pos -range speed for 10 minutes 2. Operate blade control lever (4) to t keep the relieve t 3. Finally, blade raised to the maximu he circuit for 10 minutes. operate blade control lever (4 to opera If the oi raised, t equipme te the blade and ripper cylind l temperature in the work e here will be a time lag in th nt and steering. 4.

After wa rm-up is completed, check g for prop Continu coolant range (B (A): Whi (B): Gre (C): Red er operation. If any problem i REMARK If the power train oil temperature is not ra ised sufficiently, it will take longer to accelerate to the maximum speed. 5. Check f distribut 5. Check f or abnormal exhaust gas color, noise, or vibration. If any problem is found, contact your Komatsu or.