. MAINTENANCE SERVICE PROCEDURE WHEN REQUIRED CLEAN INSIDE OF COOLING SYSTEM WARNING *: Permanent type antifreeze shall meet the requirements of ASTM D3306-03. Stop the machine on level ground when cleaning or changing the coolant. The coolant has the important function of preventing corrosion as well as preventing freezing. Even in the areas where freezing is not an issue, the use of antifreeze coolant is essential. Komatsu machines are supplied with Komatsu Supercoolant (AF-NAC). Komatsu Supercoolant (AF-NAC) has excellent anticorrosion, antifreeze and cooling properties and can be used continuously for 2 years or 4000 hours.
Komatsu Supercoolant (AF-NAC) is strongly recommended wherever available. To maintain the anticorrosion properties of Supercoolant (AF-NAC), always keep the density of Supercoolant between 30% and 68%. When using Komatsu Supercoolant (AF-NAC), there is no need to use a corrosion resistor. When no corrosion resistor is used, use the special cover (600-411-9000).Please consult your Komatsu distributor about the method of installing. Mixing rate of water and antifreeze 4 - 21 Immediately after t he engine i s stopped, the coolant is at a hig h temperature and th e radiator is under high i nternal pressure.
If the c ap is r emove d to drain t he coolant in t his conditio n, ther e is a hazard of burns. Wait for the temperature to go down, then turn th e cap slowly to release the pressure before r emoving it . Cleani ng is c arried out with th e engine ru nning. When s tandin g up or leaving the operator's seat , set the wor k equipment lock lever a nd th e parki ng brake le ver to the LOCK position. For de tails o f starti ng the eng ine, see "C HECK BEFOR E STARTING ENGINE, ADJU ST (PAGE 3-71)" and "STARTING ENGINE (PAGE 3-93) " in the OPERATI ON section Never enter front th e machine when the engine is r unning. There i s danger of touching t he fan.
Clean th e inside of t he coolin g system, change t he c oolant and replace the corrosion resistor according to the t able below. Antifreeze coolant Interval of cleaning inside of cooling system and changeing antifreeze coolant Replacing corrosion resistor Komatsu supercoolant (AF-NAC) Every two years or every 4000 hours whichever comes first unnecessary Permanent type antifreeze (All-season type, *) Every year (autumn) or every 2000 hours whichever comes first Every 1000 hours and when cleaning the inside of the cooling system and when changing coolant Min.
atmospheric temperature °C A bove -10 -15 -20 -25 -30 -35 -40 °F Above 14 5 -4 -13 -22 -31 -40 Amount of antifreeze Liters 36 43 49 55 60 65 70 US agl 9.51 11.36 12.95 14.53 15.85 17.17 18.49 Amount of Liters 84 77 71 65 60 55 50 US agl 22.19 20.34 18.76 17.17 15.85 14.53 30 36 41 46 50 54