. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE 4 - 46 4. Operate switch (3) o f the electric priming pump to the ON position. Lamp (4) wi start. ll flash and the electric priming pump will REMARK ump switch has a built-in timer, and this actuates and stops the pump automatically. hing, the electric priming pump will stop, but this does not indicate any abnormality.
The electric priming p ump switch has a built-in timer, and this actuates and stops the pump automaticall While the lamp is flas hing, the electric priming pump will stop, but this does not in dicate any abnormality If the switch is turned t o the OFF position when the lamp is lighte d up, the lamp will go out and the electric p riming pump will stop. 5. When the specified t priming pump stops. 6. If the fuel has been d maintenance has bee switch (3) for the el automatically (lamp g 7. When the lamp (4) g 8. After the air is compl valve (2). If the engine does not the air. NOTICE 5. When the specified t ime (approx.
7 minutes) has passed, lamp (4) automatically goes out and the electric lectric 6. If the fuel has been d rained from the fuel circuit, such as whe n the engine has r un out of fu el and stopp ed, or n carried out on the fuel hoses or tubes, or the supply pum p has been replaced, tu rn the ectric priming pump to the ON position again after the electric priming pump stops oes out). oes out, the air bleed operation is completed. ump stops 7. When the lamp (4) g oes out, the air bleed operation is comple etely bled from the fuel circuit and the en gine starts, stop t he engine and close air bleed start, the air bleed operation has probably not been complet ed.
Repea t Steps 1-5 to bleed tor rotating continuously for more than 20 seconds. ait for at least 2 minutes before trying to start the engine again. Do not keep the starting mo tor rotating continuously for more than 20 sec If the engine will not start, w ait for at least 2 minutes before trying to start