. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE AND BEVEL GEAR CASES), ADD OIL (PAGE 3-78)". WASH SCAVENGING PUMP STRAINER 1. Loosen mounting bolts (8) of the scavenging pump strainer, then remove strainer (9). 2. Remove any dirt stuck to strainer (9), then wash it in clean diesel oil or flushing oil. Wash the removed parts and the inside of the case at the same time. tighten 4 - 68 7. Refill the specified quantity of oil through oil filler (F). 8. Check that the oil i s at the specified level. For details, see " CHECK OIL LEVEL IN CASE (INCL. TR ANSMISSION, TORQU E CONVERTER 3. Loosen bolt (10), re move bracket (11) and c over (12) , then take out strainer (13). 4.
Remove any dirt st uck to strainer (13), then wash it in clean diesel fuel or flushing fluid. Clean the inside of the case and the remo ved parts at the same tim e. CHECK, CLEAN FUEL S 1. Remove cover (1) at the bottom of the fuel tank at th e rear of the machine. (6 bo Close fuel supply v 3. Remove cap (3), th en wash the strainer and strainer The strainer forms one unit with cap (3). 4. After checking and cap (3). 5. Install the strainer, then open fuel supply va 6.