. MAINTENANCE SERVICE PROCEDURE METHOD OF RELEASING PRESSURE IN HYDRAULIC CIRCUIT 4 - 81 1. Lowe r the wor k equipment to the gr ound. Set t he parkin Carry out Steps 3 - 5 within 15 seconds . When the engine i s stopped, th e pressu re in th e accumulator gradually goes down. For thi s reason, th e release can only be c arried ou t immediatel y after th e engin e is s topped. 3. Stop the engi 4. Turn the starti ng switch to t he ON p osition 5. FREE (F), then fully t the blade co nt, rear, left, ntrol leve and right r and ripper to release th control lever e pressure in the h ydraulic 6. Set t he work e quipment loc k lever t o the L OCK position and turn the starting switch t o the OFF p