. OPERATION EXPLANATION OF COMPONENTS 3 - 23 FAN ROTATION SELECTOR SWITCH Set this switch (6) to the (b) CLN position to select th e clean m ode for the f an. he switch is released, it returns automatically to the (a) . When t he switch is relea sed, it returns a utomatically to the (a position When t he clean mode is selected, the fa n operation confirmation lamp lig hts up. When th e clean mode is being used, turn the switch (6) to the righ to retur n to the normal m ode. The fan op eration conf irmation l amp goes ou t. The cle an mode is used to blow dust and dirt off the radiator f ins. In this mode, the coolin g fan rotates a t the f ullest speed.
When o perating the coo ling fan rotation selector swi tch, turn the engine starting switch k ey to the OFF positi on to make s ure that the engi ne is not running REMARK The coo ling fan rotation selector switch does not wo rk when i t is operated while the engi ne is running. In that c ase, the cooling fan operation co nfirmation la mp flash es to indicate that the fan rot ation cannot b e changed. The coo ling fan rotation selector switch returns to t position. whe ngine starting switch key is tur ned to the OFF For clea ning procedure FINS (P AGE 4-34)". INFORMATION SWITCH This sw itch (7) is used to carry out the sw itching of th e information monitor display mode a ance mode.
nd the switching of the cursor with the es to left es to right mainten (a) posi tion: Cursor mov (c) posi tion: Cursor mov ADDITIONAL HEATER S (if equip This sw itch (8) is used t o actuate the ho t water heat (a) posi tion: Hot water h eater OFF eater Lo (ON) eater Hi (ON) (b) posi tion: Hot water h (c) posi tion: Hot water h