Arctic Cat TRV — Arctic Cat TRV User Manual

Prevention A. Brakes 4. OIL AND FUEL Squeeze your hand brake lever. If it feels soft or “squishy,” it could be low on fluid or have a leak — refer to the General Main- tenance section of this Operator’s Manual for instructions. Don’t use the ATV until the brakes are operating normally. Start with a full tank of gas before every ride, and while you’re at it, top off the oil. Don’t forget to check for fluid leaks around the ATV. Watch the overheat lamp to ensure the engine coolant level is adequate. Check: 1. Hand brake lever 2. Rear foot brake 3. Brake lever lock Check: 1. Gas 2. Oil 3.

Fluid leaks Test the brake lever lock and see if it locks the hand brake lever into position; then disengage it to release the brake. Be sure the rear foot brake near the footrest is working; your brakes could fail during a ride if they’re not maintained. 5. CHASSIS AND DRIVE TRAIN Grass and leaves can gum-up your sus- pension and shocks. Clear and clean the suspension arms, shock springs, and fenders. Check smoothness by turning the handlebar full-left and full-right. Ver- ify there is no binding, restrictions, free- play, or looseness in steering compo- nents. B. Throttle The throttle should have a free, smooth range of motion.

If it seems to “stick” at any point, refer to the General Mainte- nance section of this Operator’s Manual for instructions. Driving your ATV with a sticking throttle can turn your leisurely ride into an unwelcome accident. Don’t drive your ATV if the throttle sticks. Check: 1. Suspension arms 2. Shock springs 3. Fenders 4. Steering Check: 1. Free, smooth range of motion 6. MISCELLANEOUS ITEMS 3. LIGHTS AND ELECTRICAL Inspect your air filter. Look for debris or damage that may indicate you need to replace it. A clogged filter can stop an engine. Check your battery terminals for corrosion. Also, be sure to tighten any loose parts, nuts, or bolts.

Turn the hi-beam and lo-beam on and off to make sure they work. At the same time, verify the taillight and brakelight work. Also, check the status/warning indicators (reverse, neutral, and HI-LO beam) on the LCD when you start the ATV. Don’t drive the ATV unless all sys- tems are working. Check the ignition switch and engine stop switch. Check: 1. Air filter 2. Battery 3. Tighten parts, nuts, and bolts Check: 1. Hi-beam 2. Lo-beam 3. Taillight/brakelight 4. Status/warning indicators 5. Ignition switch 6. Engine stop switch 27 ! WARNING Indicates a hazardous situation which, if not avoided, could result in death or serious injury.