Arctic Cat TRV — Arctic Cat TRV User Manual

OFF position — All electrical circuits except the accessory plug are off. The engine will not start. The key can be removed in this position. This switch allows the operator to operate the ATV in either 2-wheel drive (rear wheels) or 4-wheel drive (all wheels). For normal riding on flat, dry, hard surfaces, 2-wheel drive should be sufficient. In situ- ations of aggressive trail conditions, 4- wheel drive would be the desired choice. To either engage or disengage the front wheels, move the switch to the 4WD posi- tion or to the 2WD position. NOTE: The accessory plug is powered by the battery at all times. ON position — The ignition circuit is complete and the engine can run.

The key cannot be removed in this position. LIGHTS position — The ignition circuit is complete and headlights and taillight are on. The key cannot be removed in this position. CAUTION Do not attempt to either engage or disengage the 4WD lock while the ATV is moving. NOTE: Leaving the ignition switch in the ON or LIGHTS posi- tion for a long period of time when the engine is not running may cause the battery to discharge. Always leave the ignition switch in the OFF position when engine is not running. On the 550/700/1000, the 4WD lock allows the operator to mechanically lock the front differential to apply equal power to both front wheels.

To engage the lock from 4WD, slide the switch up and move it fully to the left. To disengage the lock, move the switch lever to the right. Shift Lever ! WARNING This ATV has a dual-range automatic transmission with reverse and park. The 4WD lock is intended for use where minimum traction is available. NEVER EXCEED 10 MPH (16 kph) with the lock engaged. Maneuverabil- ity and handling characteristics will differ with the lock engaged. ALWAYS shift into four-wheel drive prior to engaging the front differential lock. Failure to follow this procedure may result in loss of control. Control loss can result in severe injury or even death.

Drive Select Switch 550/700/1000 FI475A Handwarmers/ Thumbwarmer (Limited) The operator’s handwarmers/thumb- warmer are controlled by a rocker-type switch on the instrument pod. There are three positions on the switch (Low/Off/ High). 500 KC342A 50