Rear Foot Brake NOTE: This ATV has safety inter- lock switches which prevent the starter motor from activating when the transmission is not in neutral. To start the ATV while in gear, depress the rear foot brake or compress the brake lever; then depress the starter button. Reverse Override Switch CF223 Pressing the rear foot brake downward will apply the brake to the rear wheels. This ATV is equipped with a reverse speed limiter system. When additional RPM is needed in reverse, depress and hold the override switch. Headlight HI/LO Switch NOTE: The override is active only when 4WD is selected.
Use the headlight HI/LO switch to select the high or low headlight beam when the ignition switch is in the LIGHTS posi- tion. When the switch is in the HI posi- tion, the high beam will illuminate. When the switch is in the LO position, the low beam will illuminate. ! WARNING Never activate the override switch while the throttle is open as a loss of control may result. Throttle Lever CF245A Engine Stop Switch FI475B Control engine RPM with the position of the throttle lever. Operate this lever with the thumb. Pushing it forward increases engine RPM and allowing it to retract decreases engine RPM. OFF position — The ignition circuit is off. The engine cannot be started or will not run.
If the engine stop switch is used to stop engine without turning off ignition switch, the battery may discharge. Throttle Limiter Screw RUN position — The ignition circuit is on. The engine can start and run. Throttle lever travel may be limited by adjusting the throttle limiter screw. The throttle limiter should be adjusted according to the operator’s skill and experience. To adjust the throttle limiter, use the following procedure. Electric Starter Button Pushing in on this button activates the starter motor.
Before starting the engine, make sure the ignition switch is in the ON position, the transmission is in neutral, the reverse shift lever is in the forward posi- tion, and the brake lever lock is engaged. 1. Loosen the jam nut. 52