Cylinder head W 01-02-02 2011 z Tighten (1) screws alternately. Note - Make sure that the stop rods are not under stress due to valve overlap when tightening the bolts. - Align toggle lever to the stop rods/valves. 01002 z Check and set valve clearance О Job card W 01-01-01 . z Clean the sealing surface on the cylinder head cover and cylinder head. 6 z Fit gasket. Note Note installation position, the gate (arrow) must face the front cover. z Mount cylinder head cover and tighten screws alternately. 01004 0312 1556 - 0138 3/4 © 11/2004 1 © 39143 0 © 39143 0 © 39138 0 © 39138 0 © 39139 0 © 39139 0