Deutz — Deutz 2011 Workshop Manual Level 3

2011 Cylinder head W 01-06-03 W 01-06-03 Check valve guide Tools - Commercial tools Magnetic measuring stand References - W 01-05-01 - Special tools 100 400 - Meter Note - New valves are used for testing. - If the wear limit is reached, the valve guide has to be changed. Check valve guide 6 z Remove valves О Job card W 01-05-01. z Check valve guide for visible signs of wear. z Attach magnetic measuring stand and insert meter. z Insert new valve. z Apply stylus to the valve head with pre-tension (arrow) and set meter to ”0”. Measure valve shaft clearance z Move valve to and fro in direction of arrow.

Note - The end of the valve shaft must be flush with the valve guide to measure the valve shaft clearance. - The whole tilt angle must be taken into consideration. 01 33 01 34 © 11/2004 0312 1561 - 0138 1/2 © 33881 1 © 33881 1 © 39172 0 © 39172 0