Deutz — Deutz 2011 Workshop Manual Level 3

2011 Drive system W 02-01-07 W 02-01-07 Check crankcase Tools - Commercial tools Magnetic measuring stand Micrometer gauge Internal measuring device Prisms Hardness tester References - W 02-04-01 Note The rework stages are marked on the outer contour of the crankshaft face on the flywheel side. H = ground main bearing pin P = ground con rod bearing pin - Special tools 100 400 - Meter Note If the crankshaft is worn it is possible to have the crankshaft repaired in our Service Centers. Check bearing pin hardness 6 z Remove crankshaft О Job card W 02-04-01 . z Place the crankshaft on prisms. z Check baring pin with hardness tester.

Note The measured values must be converted according to the table of the measuring instrument. 02 07 © 11/2004 0312 1564 - 0138 1/4 © 39176 0 © 39176 0 © 39177 0 © 39177 0