Deutz — Deutz 2011 Workshop Manual Level 3

Drive system W 02-09-03 2011 Remove piston and con rod. z Remove cylinder head О Job card W 01-04-04 . z Remove oil intake pipe О Job card W 08-04-06 . z Pull out oil dipstick (1). 6 Remove con rod bearing cover z Set lifting bearing journal in the lower dead point. z Unscrew nuts (1). Note - Use a twelve-edge box wrench. - Put down the components in the order of installation, note order of cylinders. 00 81 z Remove con rod bearing cover (2) and con rod bearing. z Press out piston and con rod. Note Set down the components in the order of installation, note cylinder order. 00 81 0312 1570 - 0138 2/8 © 11/2004 1 © 39219 0 © 39219 0 1 2 © 39220 0 © 39220 0 © 39221 0 © 39221 0