Drive system W 02-09-03 2011 Complete the con rod and the piston z Insert a spring ring. Note - The ring joint must face the piston base, X = +/- 20° - Pay attention to correct fit of the locking ring in the groove. z Insert con rod in piston. 6 Note The symbol flywheel/crankshaft (1), on the piston base, must face left and the numeric identification (2) on the con rod up. z Oil lightly and press in the piston bolt. z Insert the second spring ring. Note - The ring joint must face the piston compression bolt. - Pay attention to correct fit of the spring ring in the groove. 0312 1570 - 0138 5/8 © 11/2004 X © 39257 0 © 39257 0 6010 2 1 © 39259 0 © 39259 0 © 39260 0 © 39260 0