2011 Crankcase W 03-03-01 W 03-03-01 Check cylinder Tools - Commercial tools Internal measuring device Micrometer gauge Note - The crankshaft bearing cover must be mounted properly to measure the cylinder. - If the wear limit is reached, it is possible to rework the crankshaft for further use. Use pistons and piston rings according to the repair stage. - Special tools 100 400 - Meter References - W 01-04-04 z Remove cylinder head О Job card W 01-04-04 . 6 Check cylinder z Check cylinder for visible signs of wear. Check the cylinder running surface Prepare internal measuring device. z Mount probe bolt for the appropriate measuring range in internal measuring device.
z Install meter with approx. 1 mm pre-tension in the internal measuring device. z Set micrometer gauge to 94 mm. z Balance internal measuring device between the test surfaces of the micrometer gauge and set the meter at the reversal point of the pointer to ”0”. © 11/2004 0312 1575 - 0138 1/2 © 39239 0 © 39239 0 © 36094 1 © 36094 1