Mack Trucks V-MAC IV — Mack Trucks V-MAC IV — спецификация (EN)

MID 128-SID 21 MID 128-SID 21 MID 128 SID 21 — CAM SPEED SENSOR FMI 2 Data Erratic, Intermittent or Incorrect Failure Mode Identifier (FMI): 2 (Data Erratic, Intermittent or Incorrect), 3 (Voltage Above Normal, or Shorted To High Source), or 8 (Abnormal Frequency or Pulse Width or Period) Conditions for fault code: Phase Error - Incorrect correlation between CAM and Crank Sensor Parameter Identification (PID): S21 Possible causes: Faulty connector Message Identification (MID): 128 Faulty CAM Sensor harness Circuit Description: The CAM Speed Sensor is an inductive device.

As the camshaft turns, the tip of the CAM Speed Sensor senses the holes in the camshaft drive gear and sends a series of voltage pulses to the Engine Management System (EMS) Module. The frequency of the pulses is translated into engine speed and position by the EMS Module. The EMS Module uses this information along with the information from Crank Speed Sensor to synchronize fuel injection. Faulty CAM Sensor Reaction from Engine Management System (EMS) Module: Engine will be started using Crank Speed (Flywheel) signal Noticeable external symptoms: Increased fuel consumption Location: The CAM Speed Sensor is located on top right rear of engine.

FMI 3 Voltage Above Normal, or Shorted To High Source Electrical problems can cause this fault to be generated, and electrical diagnostics are provided in this section. Mechanical problems can also cause temporary or permanent speed signal errors. After all electrical possibilities have been ruled out, check mechanical conditions that could cause vibration or signal errors. Such conditions include but are not limited to: Conditions for fault code: Missing Signal from CAM Sensor Open in the CAM Sensor Circuit Short to battery in the CAM Sensor Circuit Short to ground in the CAM Sensor Circuit Possible causes:

Faulty Engine Vibration Damper Faulty CAM Sensor harness Contaminated sensor tips Reaction from Engine Management System (EMS) Module: Contaminated Cam Gear face Excessive Camshaft end play Engine will be started using Crank Speed (Flywheel) signal Improperly adjusted sensor Improperly balanced engine components Noticeable external symptoms: Faulty engine timing cover. Increased engine start time Loss of engine power Page 107 MID 128-SID 21