Mack Trucks V-MAC IV — Mack Trucks V-MAC IV — спецификация (EN)

MID 144-PPID 265 MID 144-PPID 265 MID 144 PPID 265 — VEHICLE SPEED SENSOR SUPPLY FMI 4 Voltage Below Normal, or Shorted To Low Source Failure Mode Identifier (FMI): 3 (Voltage Above Normal, or Shorted To High Source), 4 (Voltage Below Normal, or Shorted To Low Source) Conditions for fault code: Abnormally low voltage Parameter Identification (PPID): P265 Possible causes: Message Identification (MID): 144 VSS harness shorted low Faulty VSS Circuit Description: The Vehicle Speed Sensor (VSS) is an inductive sensor. When the vehicle is moving, the transmission output shaft speedometer gear teeth rotate past the VSS tip and a pulsed signal voltage is generated.

The Vehicle Electronic Control Unit (VECU) monitors the frequency of the signal generated by the VSS, to calculate the road speed. The air gap between the sensor and the toothed gear influences the VSS signal output and should be checked if erratic or inaccurate speedometer readings are reported. Reaction from Vehicle Electronic Control Unit (VECU): Yellow lamp is illuminated Noticeable external symptoms: N/A Location: The Vehicle Speed Sensor (VSS) is located in the rear of transmission, near the output shaft. FMI 3 Voltage Above Normal, or Shorted To High Source Conditions for fault code: Abnormally high voltage Possible causes:

VSS harness shorted high Faulty VSS Reaction from Vehicle Electronic Control Unit (VECU): Yellow lamp is illuminated Noticeable external symptoms: N/A Page 164 MID 144-PPID 265