MID 128-PID 97 MID 128-PID 97 MID 128 PID 97 — WATER IN FUEL SENSOR FMI 4 Voltage Below Normal, or Shorted To Low Source Failure Mode Identifier (FMI): 3 (Voltage Above Normal, or Shorted To High Source), 4 (Voltage Below Normal, or Shorted To Low Source), 5 (Current Below Normal or Open Circuit), 14 (Special Instructions) Conditions for fault code: Short to ground on measuring line Voltage on measuring line is below normal Possible causes: Parameter Identification (PID): P97 Harness is shorted to ground Message Identification (MID): 128 Open circuit in the harness Circuit Description:
Voltage from the Engine Management System (EMS) Module is applied to the Water In Fuel (WIF) Sensor when the ignition switch is in the ON position. If water is detected, the WIF sensor will notify the driver to drain the water from the bowl by illuminating a lamp on the dash of the vehicle. Reaction from EMS module: MIL lamp will illuminate Noticeable external symptoms: Will give water in fuel indication FMI 5 Location: The Water In Fuel (WIF) Sensor is located in the transparent plastic bowl under the fuel filter. The fuel filter is located on the left side of the engine. Current Below Normal or Open Circuit Conditions for fault code: Open circuit FMI 3 Possible causes:
Voltage Above Normal, or Shorted To High Source Open circuit in the harness Reaction from EMS module: Conditions for fault code: MIL lamp will illuminate This fault will become active when the EMS Module detects that the Water In Fuel supply voltage is above 4.75 volts. Actual water in the fuel filter will not produce a fault. Noticeable external symptoms: N/A FMI 14 Possible causes: Special Instructions Harness is shorted to battery Open circuit in the harness Conditions for fault code: Priming pump active (no error) Reaction from EMS module: MIL lamp will illuminate Possible causes: Noticeable external symptoms:
No error; used for indication when priming pump is active Possible undetected water in the fuel supply. This can cause the engine to stop. Reaction from EMS module: Uneven running MIL lamp will illuminate MIL lamp illuminated Noticeable external symptoms: N/A Page 28 MID 128-PID 97