Mack Trucks V-MAC IV — Mack Trucks V-MAC IV — спецификация (EN)

MID 128-PID 171 MID 128-PID 171 MID 128 PID 171 — AMBIENT AIR TEMPERATURE STATUS FMI 9 Abnormal Update Rate Failure Mode Identifier (FMI): 9 (Abnormal Update Rate) Conditions for fault code: This fault will become active when the Engine Management System (EMS) Module detects that the Ambient Air Temperature message from the Instrument Cluster Module does not exist. Parameter Identification (PID): P171 Message Identification (MID): 128 Circuit Description:

The V-MAC IV system uses the J1939 data lines is used to control functions and communicates between the Vehicle Electronic Control Unit (VECU), Engine Management System (EMS) Module, Instrument Cluster Module (ICM) and accessory systems, depending on vehicle model and option content. The J1939 data lines consist of an expandable data bus allowing the addition of accessory control modules. The J1939 data lines are the primary data bus. Data is prioritized and then transmitted across the J1939 data lines to the appropriate control module.

The V-MAC IV system is designed to allow limp home engine operation with the loss of the J1939 data signal as long as the J1587 data lines are still operational. The ambient air temperature signal is sent to the Instrument Cluster Module (ICM). The ICM then transmits the ambient air temperature data to the EMS Module via the J1939 data lines. Possible causes: Faulty Ambient Air Temperature Sensor harness Reaction from Engine Management System (EMS) Module: MIL lamp will illuminate Noticeable external symptoms: MIL lamp illuminated Location: The Instrument Cluster Module (ICM) is located near left side of the dash. The EMS module is located on the left side of the engine block.

Normal Engine Coolant Temperature Sensor Parameters: The Ambient Air Temperature Status code will set when a fault is detected in the Ambient Air Temperature Sensor, the J1507/J1708 Data Lines or the Instrument Cluster Module (ICM). Page 42 MID 128-PID 171