MID 128-PID 354 MID 128-PID 354 MID 128 PID 354 — INTAKE AIR TEMPERATURE AND HUMIDITY SENSOR Reaction from Engine Management System (EMS) Module: MIL lamp will illuminate Failure Mode Identifier (FMI): 3 (Voltage Above Normal, or Shorted to High Source), 5 (Current Below Normal or Open Circuit) Humidity value is set to 100 percent Noticeable external symptoms: MIL lamp illuminated Parameter Identification (PID): P354 Turbocharger noise Message Identification (MID): 128 FMI 5 Circuit Description: The Intake Air Temperature and Humidity (IATH) Sensor contains two thermistors, and the resistance of each thermistor varies inversely to temperature.
By monitoring the current flow through each thermistor, the Engine Management System (EMS) Module calculates the temperature and humidity of the air entering the turbocharger. Current Below Normal or Open Circuit Conditions for fault code: Open in the metering circuit of the Intake Air Temperature and Humidity (IATH) Sensor Open in the 5 volt supply circuit of the Intake Air Temperature and Humidity (IATH) Sensor Location: The Intake Air Temperature and Humidity (IATH) Sensor is located in the air intake tube. Short to ground in the metering circuit of the Intake Air Temperature and Humidity (IATH) Sensor Possible causes:
FMI 3 Faulty connector Voltage Above Normal, or Shorted to High Source Faulty Intake Air Temperature and Humidity (IATH) Sensor harness Conditions for fault code: Faulty Intake Air Temperature and Humidity (IATH) Sensor Short to battery in the metering circuit of the Intake Air Temperature and Humidity (IATH) Sensor Reaction from Engine Management System (EMS) Module: Open in the ground circuit of the Intake Air Temperature and Humidity (IATH) Sensor MIL lamp will illuminate Humidity value is set to 100 percent Possible causes: Faulty connector Noticeable external symptoms:
Faulty Intake Air Temperature and Humidity (IATH) Sensor harness MIL lamp illuminated Turbocharger noise Faulty Intake Air Temperature and Humidity (IATH) Sensor Page 46 MID 128-PID 354