MID 128-PID 412 MID 128-PID 412 MID 128 PID 412 — EGR TEMPERATURE AFTER COOLER Possible causes: Faulty connector Faulty harness Failure Mode Identifier (FMI): 0 (Data Valid But Above Normal Operational Range - Most Severe Level), 4 (Voltage Below Normal, or Shorted To Low Source), 5 (Current Below Normal or Open Circuit), 10 (Abnormal Rate of Change) Faulty sensor Reaction from Engine Management System (EMS) Module: MIL lamp will illuminate Engine power will be derated according to the error torque map Parameter Identification (PID): P412 Message Identification (MID): 128 Noticeable external symptoms: Location:
The EGR temperature probe and heater probe are located in the EGR tube between the EGR cooler and the intake manifold. The EGR Sensor assembly is supplied from the manufacturer as a single calibrated unit. The components of the sensor are not to be replaced individually. MIL lamp illuminated Engine unresponsive FMI 5 Current Below Normal or Open Circuit FMI 0 Conditions for fault code: Data Valid But Above Normal Operational Range - Most Severe Level Short to battery in the metering side of the EGR Sensor circuit Open in the metering side of the EGR Sensor circuit Possible causes:
Extreme driving conditions Open circuit in the ground line of the EGR Sensor circuit EGR cooler failure Possible causes: Reaction from Engine Management System (EMS) Module: Faulty connector MIL lamp will illuminate Faulty harness Engine power will be derated according to the error torque map Faulty sensor Reaction from Engine Management System (EMS) Module: Noticeable external symptoms: MIL lamp illuminated MIL lamp will illuminate FMI 4 Noticeable external symptoms: Voltage Below Normal, or Shorted To Low Source MIL lamp illuminated Engine unresponsive Conditions for fault code: Short to ground on the metering side of the EGR Sensor circuit Page 48 MID 128-PID 412