MID 128-PPID 328 MID 128-PPID 328 MID 128 PPID 328 — AFTER TREATMENT INJECTION SHUT OFF VALVE FMI 5 Current Below Normal or Open Circuit Failure Mode Identifier (FMI): 3 (Voltage Above Normal, or Shorted To High Source), 4 (Voltage Below Normal, or Shorted To Low Source), 5 (Current Below Normal or Open Circuit), 7 (Mechanical System Not Responding or Out Of Adjustment), 14 (Special Instructions) Conditions for fault code: Open circuit Possible causes: Faulty harness Actuator failure Parameter Identification (PPID): P328 Reaction from Engine Management System (EMS) Module: Message Identification (MID):
128 MIL lamp illuminated FMI 3 FMI 7 Voltage Above Normal, or Shorted To High Source Mechanical System Not Responding or Out Of Adjustment Conditions for fault code: Conditions for fault code: Circuit shorted to battery After Treatment Fuel Injector stuck closed Possible causes: Possible causes: Faulty harness Shut off valve stuck closed Actuator failure Reaction from Engine Management System (EMS) Module: Reaction from Engine Management System (EMS) Module: MIL lamp illuminated MIL lamp illuminated FMI 14 FMI 4 Special Instructions Voltage Below Normal, or Shorted To Low Source Conditions for fault code: Conditions for fault code:
Circuit shorted to ground After Treatment Fuel Injector leaking Possible causes: Possible causes: Faulty harness Sensor failure Actuator failure Reaction from Engine Management System (EMS) Module: Reaction from Engine Management System (EMS) Module: MIL lamp illuminated MIL lamp illuminated Page 56 MID 128-PPID 328