MID 128-PPID 437 MID 128-PPID 437 MID 128 PPID 437 — AFTER TREATMENT INJECTOR FUEL PRESSURE SENSOR Reaction from Engine Management System (EMS) Module: MIL lamp illuminated Failure Mode Identifier (FMI): 2 (Data Erratic, Intermittent or Incorrect), 3 (Voltage Above Normal, or Shorted To High Source), 5 (Current Below Normal or Open Circuit), 10 (Abnormal Rate of Change) FMI 5 Current Below Normal or Open Circuit Conditions for fault code: Open circuit in the 5 volt supply Parameter Identification (PPID): P437 Short circuit to ground in the metering line Message Identification (MID): 128 Open circuit in the metering line FMI 2 Possible causes:
Data Erratic, Intermittent or Incorrect Faulty harness Sensor failure Conditions for fault code: Sensor is not rational Reaction from Engine Management System (EMS) Module: Possible causes: MIL lamp illuminated Faulty shut off valve Sensor failure FMI 10 Abnormal Rate of Change Reaction from Engine Management System (EMS) Module: Conditions for fault code: MIL lamp illuminated After Treatment Injector Fuel Pressure Sensor stuck FMI 3 Possible causes: Voltage Above Normal, or Shorted To High Source Sensor failure Conditions for fault code:
Faulty shut off valve Short circuit to battery on the metering side Injector failure Open circuit in the ground line Reaction from Engine Management System (EMS) Module: Possible causes: MIL lamp illuminated Faulty harness Sensor failure Page 67 MID 128-PPID 437