MAINTENANCE F. FUEL LEVEL 1. Turn “ON” the ignition key and the fuel level gauge in the cluster gauge will indicate the fuel tank level. See Figure 4.15A. 2. To refuel the machine, use the ignition key to remove the fuel tank cap. Do not remove the fuel screen for fueling. Refill fuel tank to full mark to reduce air volume (condensation). Failure to do so could create problems such as rusting and fuel freezing, as well as other associated problems. NOTE If refilling is done by means of the optional auxiliary fuel pump (standard for european machines only), proceed as follows: a. Use the ignition key to remove the fuel tank cap. b.
Open battery access cover, remove the filter end of the fuel pump suction hose from its storage housing and insert the fuel suction hose into fuel supply reser- voir. See Figure 4.15B. c. Locate the auxilliary fuel pump switch inside the stor- age box access door. Place the switch in the “ON” po- sition. See Figure 4.15C. Place pump switch in the “OFF” position when fuel tank is full. FIGURE 4.15A 4 Fuel pump suction hose Use ignition key to remove cap NOTE Delivery rate of the auxilliary fuel pump is 30 liters per minute (7.9 U.S. Gal per minute). FIGURE 4.15B d. After removing fuel suction hose from fuel supply res- ervoir, coil hose and place filter into its storage hous- ing.
Replace fuel strainer and fuel filler cap. Fuel pump FIGURE 4.15C SK210(LC)/SK250(LC)–VI Dynamic Acera OM, 09/00 Rev.2 4-15