MAINTENANCE F. HYDRAULIC LINES, TUBES AND HOSES Since there is no definite time table for the replace- ment of hydraulic lines, tubes and hoses, inspect the following periodically for tightness and signs of damage. Replace all damaged lines, tubes and hoses with new parts. Refer to the parts manual for correct part numbers when ordering. WARNING HEATER HOSE DO NOT BEND, STRIKE OR DAMAGE HIGH PRESSURE LINES. DO NOT INSTALL BENT OR DAMAGED LINES, TUBES OR HOSES. REPLACE ALL DAMAGED LINES, TUBES AND HOSES IMMEDI- ATELY. TIGHTEN ALL LOOSE FITTINGS AND CONNECTIONS TO THE PROPER TORQUE VALUE. CLEAN UP ALL FUEL AND OIL SPILLS IMMEDIATELY TO HELP PREVENT FIRES.
NEVER USE HANDS TO CHECK FOR LEAKS CAREFULLY INSPECT ALL LINES, TUBES AND HOSES FOR: 1. FITTINGS & CONNECTIONS DAMAGED OR LEAKING. 2. OUTER COVERING OF HOSES WORN, CUT OR DAMAGED EXPOSING WIRE REINFORCEMENT. 3. HOSE SWELLING OR “BALLOONING”. 4. EVIDENCE OF HOSE BEING KINKED OR COLLAPSED. 5. STEEL PROTECTIVE COVERING WORN OR DAMAGED. 6. LOOSE FITTINGS AND CONNECTIONS. MAKE CERTAIN ALL CLAMPS, GUARDS AND HEAT SHIELDS ARE IN PLACE AND SECURE. THIS WILL HELP PREVENT VI- BRATION, EXCESSIVE WEAR OF COMPONENTS AND EXCES- SIVE HEAT DURING OPERATION. FIGURE 4.60A 4 BOOM HOSES FIGURE 4.60B ARM CYL. HOSES 1. Heater Hoses Inspect the heater hoses between heater and engine for signs of damage and wear.
See Fig- ure 4.60A. 2. Boom Cylinder Hoses & Tubes Inspect boom head and rod hoses and tubes for damage, wear and loose connections. See Figure 4.60B. FIGURE 4.60C 3. Arm Cylinder Hoses & Tubes Inspect arm head and rod hoses and tubes for damage, wear and loose connections. See Fig- ure 4.60C. BUCKET CYL. HOSES AND LINES 4. Bucket Cylinder and Nibbler/Breaker Hoses & Tubes Inspect bucket head and rod hoses and tubes for damage, wear and loose connections. See Figure 4.60D. 5. Fuel Lines and Hoses Inspect fuel lines and hoses for damage, wear and loose connections. Repair or replace fuel lines and hoses before operating the machine.
NIBBLER/BREAKER HOSES AND LINES FIGURE 4.60D 4-60 SK210(LC)/SK250(LC)–VI Dynamic Acera OM, 09/00 Rev.2