Kobelco — C. Removing Machine From Storage 4-

MAINTENANCE 4.13 MACHINE STORAGE A. Prepare Machine Perform the following procedure to prepare the machine for long term storage. 1. Perform all inspection and maintenance pro- cedures as previously described in this sec- tion. 2. Thoroughly clean the machine, inspect for damaged or worn parts and components and replace or repair all damaged or worn parts. 3. Completely fill fuel tank with fresh, clean fuel to aid in preventing condensation of mois- ture inside the fuel tank. Make sure to use an anti-algae additive in the fuel tank. 4. Move machine to an indoor location for stor- age. 5. Operate bucket and arm completely “IN” ex- tending cylinders.

Then lower boom until at- tachment is resting on the floor. See Figure 4.62. 6. Coat cylinder rods with a heavy coat of grease to prevent corrosion during storage. 7. Remove batteries and store in a well venti- lated, warm area. CAUTION Protect CPU and all electrical components from water and steam when cleaning the machine. 4 POSITION MACHINE AS SHOWN INSIDE A STORAGE BUILDING HEAVILY GREASE ALL CYLINDER RODS TO PREVENT CORROSION FIGURE 4.62 B. Care During Storage 1. Every 30 days during storage, it will be nec- essary to start and run the machine to circu- late the fluids through the systems. Before starting clean cylinder rods and after running re-grease cylinder rods. C.

Removing Machine From Storage 1. Perform all inspection and maintenance pro- cedures as described in this section before bringing machine out of storage for normal operation. 2. Remove drain plugs from travel motor and swing gear reduction units to drain off any moisture which may have accumulated dur- ing storage. 3. Carefully and closely inspect all hydraulic hoses after long periods of storage for signs of deterioration. Replace all hoses showing these signs. NOTE Run and operate machine for approximately 1 hour to allow all fluids to circulate well and reach normal operat- ing temperatures. 4-62 SK210(LC)/SK250(LC)–VI Dynamic Acera OM, 09/00 Rev.2