Komatsu — SELECTION AND INSPECTION OF TIRES

. MAINTENANCE SERVICE PROCEDURE CHECK OF INFLATION PRESSURE OF TIRES AND INFLATION OF THEM WARNING NOTICE If the tires are used when the inflation pressure is less than the value given in the table above, the rim may be damaged. Always keep the tire inflation pressure within +0 to +0.03 MPa (0.3 kg/cm 2 , 4.3 PSI) of the value in the table above. 4 - 38 When inflati ng a tire, check t hat any p erson will n ot enter the working area and use an air chuck whi ch has a c lip and whi ch can be fix ed to the air valve. While inflati ng the tire, check t he inflati on pressure occasional ly so that it will not ris e too high.

If the rim is n ot fitted normally , it may b e broken an d scattered while the tire is inflate d. Accordingly, place a g uard aroun d the tire an d do not work in fron t of the rim but w ork on th e tread side of the tire. f the rim Abnormal d rop of inflation p ressure and abnorm al fitting o rim indicate a tr ouble in the tire or rim. In this case, be sure to ask a tire repair shop for repair. bserve the specified inflation pressure. st the inflation pressure of the tires just after high-speed vy-load work. Be sure to o bserve the specif ied inflati on pressur Do not adju st the inflation pr travel or hea vy-load work.

Check Measure the i nflation pressu re with a tire press ure gauge , while the tires are cool, before s Inflation of tires ation pressure properly. Adjust the infl ation pressure properly When inflatin g a tire, use an air chuc k which ca n be fixed to the air valve of the tire as sho wn in the figure. Do not work in front of the rim but w ork on th e tread si de of the ti The proper in flation pressure is show n below. Tire size Inflation pressure [MPa (kg/cm2, PSI)] 29.5-R25 VLT (standard) 0.37 (3.8, 54.0) 29.5-R25 VKT (standard) 29.5-R25 XADT (standard) 0.39 (4.0, 56.8) 29.5-R25 RL2+ (standard) 0.40 (4.1, 58.2) 875/65 R29 (if equipped) 0.44 (4.5, 63.9)