Komatsu — REPLACE FUEL PREFILTER CARTRIDGE

. MAINTENANCE SERVICE PROCEDURE REPLACE FUEL PREFILTER CARTRIDGE WARNING Container to catch the oil Prepare a filter wrench 1. Set an oil receiving container under the fuel prefilter cartridge. 2. Turn water separator cup (2) installed to the bottom of filter cartridge (1) to the left and remove it. (Use this cup again.) 3. Using a filter wrench, turn filter cartridge (1) counterclockwise to remove it. 4. Install cup (2) removed before to the underside of the new fuel prefilter cartridge. (At this time, be sure to replace the O-ring with new one.) Tightening torque of cup: 10 Nm {1.0 kgm, 7.2 lbft} 5. Clean the filter holder.

NOTICE When filling the filter cartridge with fuel, carry out the filling operation with cap (A) fitted. Cap (A) acts to prevent the entry of dirt or dust into the filter cartridge. 6. Fill the filter cartridge with clean fuel through the 8 small holes (B) in the new filter cartridge. 7. Coat the packing surface of the filter cartridge with oil. 8. Remove filter cartridge cap (A) and install to the filter holder. 4 - 57 After the engine has been operated, all parts are at high temperature, so do not re place the filter immediately. Wait for all parts to cool down before starting the operation. e is running.

High pressure is generated inside the engine fuel piping system when the engin When replacing the filter, wait for at least 30 seconds after stopping the engine replacing the filter. Do not bring any fire or flame close. to let the internal pressure go down before NOTICE Genuine Komatsu fuel filter cartridges use a special filter that has highly efficie nt filtering ability. When replacing the filter cartridge, always use a genuine Komatsu part. The common rail fuel injection system used on this machine consists of more p recise parts than the conventional injection pump and nozzle. If any part other than a genuine Komatsu filter cartridge is used, dust or dirt may system.

Always avoid using substitute parts. get in and cause problems with the injection When carrying out inspection or maintenance of the fuel system, pay more atten tion than normal to the entry of dirt. If dirt is stuck to any part, use fuel to wash it off completely.