. MAINTENANCE SERVICE PROCEDURE CLEAN, CHECK RADIATOR FINS AND AFTER COOLER FINS WARNING around dust and debris, there of injury. Always wear such as clamps. can be 4 - 61 If protective glasses and mas is danger protective equipmen If cause overheating of the engin e, so always cle an or ca rry out inspection and take th e necessary Cleaning can be carrie d out by using j ets of air , steam, or water, but be careful not to le t the nozzle co ntact the When using compress ed air or steam, keep th angle to t he radiator a nd after cooler. Examine the rubber h found, replace the ho ose, and if any c se.
In addition, racks or check al brittle so for plac loose es are hose NOTICE If s tea damaged, so keep a good d istance in betwee n when c leaning Use the following values as a benchmark. Jet p ressure: Lower than 9.8 MPa (100 kg/ Nozzle diameter: Less th an 2 mm (0.08 in) Distance b etween nozzle and fin (A): More than 100 mm (4 in