. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE REPLACE CORROSION RESISTOR CARTRIDGE WARNING Prepare a filter wrench 4 - 66 7. Loosen wing bolt (4) which (3). Move lever (5) up an bleeding plug (2) until bub is fixing lever (5) of priming pump d down to let fuel flow out of air bles do not come out any more. 8. Tighten air bleeding plug ( priming pump (3) securely Tightening torque for air 7.8 to 9.8Nm{0.8 to 1kg Tightening torque for wi 6.9 to 12.7Nm{0.7 to 1.3 2) and then tighten wing bolt (4) of to lock lever (5). bleeding plug m} ng screw kgm} rtridge, start the engine and check 9.
After replacing the filter ca that there is no leakage of there is any leakage of fu cartridge. If there is still lea remove the filter cartridge, damage or foreign materia is found in the packing, re then repeat Steps 3 - 9 to i fuel from the filter seal surface. If el, check the tightening of the filter kage of fuel, follow Step 1 and 2 to then check the packing surface for l. If any damage or foreign material place the cartridge with a new part, nstall the filter cartridge. All the engine parts are at high tem perature after the engine has been operated, so never replace th e cartridge immediately after finishing operations. e replacing the cartridge.
Wait for the oil to cool down befor 1. Set valve (1) at the top of th position, to close it. 2. Set the container to catch 3. Using a filter wrench, remo e corrosion resistor to the CLOSED the water under the cartridge. ve cartridge (2). t the steel surface of the new filter oil, then install it. ntil the gasket contacts the seal then tighten a further 2/3 turns. htened too far, the gasket will be to leakage of water. If the filter is too om the gap at the gasket, so always . position to open it. e, start the engine and check that there is no leakage of water from the filter sea age of water, check the tightening of the filter cartridge. 4.
Clean the filter holder, coa cartridge with clean engine 5. When installing, tighten u surface of the filter holder, If the filter cartridge is tig damaged and this will lead loose, water will also leak fr tighten the correct amount 6. Set valve (1) to the OPEN 7. After replacing the cartridg surface. If there is any leak age of water, check the tightening of the filter cartridge.