. ATTACHMENTS, OPTIONS HANDLING PAYLOAD METER HM 6 - 31 *3: (1) If more than 2600 cycl es are saved in memory (s pace for 3 00 cycle s remaining) , "L:FUL" flas (2) If more cycles are reco rded and the total exceeds 2900 cycl es, numbers 2901, 29 02, etc. are s aved in memory, but the oldest cycle da ta are deleted in turn. (3) If this error code flash es, download to the PC, th en delete a ll data. For details, see Section " (e) Data all clear operation (PAGE 6-28 *4: Engine ON/OFF data (1) If more than 105 times are saved in memory (sp ace for 10 t imes re maining), "E: FUL" flashes. (2) If more times of engine ON/OFF are recorded and the total ex ceeds 1 15 times, nu mbers 116, 11 7, etc.
a re s aved in memory, but the old est engine ON/OFF data a re deleted in turn. (3) If this error code flash es, download to the PC, th en delete a ll data. For details, see Section " (e) Data all clear operation (PAGE 6-28 *5: When equalizer bar co (1) If the equalizer bar is in contact with the stopper, an accurate measurement cann ot be obtaine d. If the machine is stopped empty at th e loading point, contact be tween the equaliz er bar and sto pper is detec (2) Drive the machine forw ard a little at a time until er ror code "F -FL" dis appears from the display. Set the gearshift lever at D. After stopp ing the machine, return th e gearshift lever to *6:
Articulation angle too l arge If t he dumping mode is se lected when measuring, th e measure d value i s saved imm ediately befor e the dump body is r aised. If the articulatio n angle is too large when t he measurement i s made, the a ccuracy will be poor. "F-AC" is displayed when the dumping mode has bee n selected and the articulation h as been turn ed more tha n half (approx. 22.5°) when the machine is stopped while l oaded If " F-AC" is displayed whe n dumping, set the machi ne facing st raight s o tha t the err or code is no t displayed.