CONTROL LOCATIONS AND FUNKTIONS Ignition Switch The ignition switch has three positions. OFF position - All electrical circuits are off. The engine will not start. The key can be removed in this position. ON position - The ignition circuit is complete and the engine can run. The key cannot be removed in this position. LIGHTS position - The ignition circuit is complete and the position lights are on. The key cannot be removed in this position. KM185 n Note: To illuminate the headlight, the engine must be running and the headlight switch must be in the HI or LO position. !
CAUTION Leaving the ignition switch in the LIGHTS position for a long period of time when the engine is not running may cause the battery to discharge. Always leave the ignition switch in the OFF position when engine is not running. GENERAL INFORMATION Indicator Lights 1. Turn Lights Left and Right 2. High Beam Indicator - A blue light will illuminate when the engine is running, the ignition switch is in the LIGHTS position, and the headlight switch is in the HI beam position. 3. Temperature Indicator - A red light will illuminate if the engine overheats. The light should be off during normal operation. 1 1 3 2 KM176A Liquid Crystal Display - LCD 1.
Adjust Button - Used to toggle between Clock, Hour Meter, Odometer, and Trip Meter in the display (5). In conjunction with the Mode Button (2), sets the clock and resets the trip meter to zero. Also used to toggle between MPH and km/h. 61