Headlight LI/LO/HI Switch Use the headlight LI/LO/HI switch to select the high or low headlight beam when the ignition switch is in the LIGHTS position. When the switch is in the HI position, the high beam will illuminate. When the switch is in the LO position, the low beam will illuminate. When the switch is in the LIGHT position, the front and rear position lights and the license plate light will illuminate. Electric Starter Button Pushing in on this button activates the starter motor. Before starting the engine, make sure the ignition switch is in the ON position, the transmission is in neutral, and the parking brake lock is engaged.
Throttle Lever Control engine RPM with the po- sition of the throttle lever. Operate this lever with the thumb. Pushing it forward increases engine RPM and allowing it to retract decreases engine RPM. Throttle lever travel may be li- mited by adjusting the throttle limiter screw. The throttle limiter should be adjusted according to the operator’s skill and experience. To adjust the throttle limiter, use the following procedure: 1. Loosen the jam nut (1). 2. Turn the throttle limiter screw (2) clockwise to decrease engine RPM maximum or counterclockwise to increase engine RPM ma- ximum. 3. Tighten the jam nut securely.
GENERAL INFORMATION Fuel Valve The fuel valve is incorporated in the gas tank. There are three po- sitions: ON, RES (reserve), and OFF. In the OFF position, the valve will prevent gasoline fl ow to the car- buretor. KM146A 65