Oil Level Stick There is an oil level stick for checking the engine oil level. to check the oil level, use the following procedure. n Note: The ATV sould be on level ground when checking the engine oil level. 1. Unscrew the oil level stick and wipe it with a clean cloth. 2. Install the oil level stick and thread it into the engine case. 3. Remove the oil level stick; the engine oil level should be above the „L“ mark but not higher than the „F“ mark. ! CAUTION Do not overfi ll the engine with oil. Always make sure the oil level is above the “L” mark but nor higher than the “F” mark. GENERAL INFORMATION SEAT LATCH 1.
To remove the seat, lift up on the latch release (located at the rear of the seat); then raise the rear of the seat and slide it rear- ward. 2. To lock the seat into position, slide the front of the seat into the seat retainer and push down fi rmly on rear of seat. The seat should automatically lock into position. ! WARNING Make sure the seat is secure before mounting the ATV. Severe per- sonal injury may result if the seat is not properly secured. 67