PREPARATION FOR STORAGE ! CAUTION Prior to storing the ATV, it must be properly serviced to prevent rusting and component deterioration. Arctic Cat recommends the following procedure to prepare the ATV for storage. An authorized Arctic Cat ATV dealer should perform this service; however, the owner/operator may perform this service if desired. 1. Clean the seat cushion (cover and base) with a damp cloth and allow to dry. 2. Clean the ATV thoroughly by washing dirt, oil, grass, and other foreign matter from the entire ATV. Allow the ATV to dry thoroughly. DO NOT get water into any part of the engine or air intake. 3.
Either drain the gas tank or add a fuel stabilizer to the gas in the gas tank. Remove the air fi lter housing cover and air fi lter. Start the engine and allow it to idle; then using Arctic Cat Engine Preserver, rapidly inject the preserver into the air fi lter opening for a period of 10 to 20 seconds. Install the air fi lter and housing cover. ! CAUTION If the interior of the air fi lter housing is dirty, clean the area before starting the engine. 4. Drain the carburetor fl oat bowl. 5. Plug the hole in the exhaust system with a clean cloth. 6. Apply light oil to the upper steering post bushing, plungers of the shock absorbers, and drive chain. 7. Tighten all nuts, bolts, cap screws, and screws.
Make sure rivets holding components together are tight. Replace all loose rivets. Care must be taken that all calibrated nuts, cap screws, and bolts are tightened to specifi cations. 8. Fill the cooling system with properly mixed coolant. 9. Disconnect the battery cables (negative cable fi rst); then remove the battery, clean the battery posts and cables, and store in a clean, dry area. 88