Komatsu — STARTING ENGINE

. OPERATION OPERATION REMARK the warming-up operation. REMARK Steps 3 and 4. 3 - 90 Immediately a fter starting the en gine, run at idle. While running th e engine, releas e the d ecelera tor pedal and do not operate th e work equipment Guideline for Cold weat her: At least 15 se 1st start af ter changing engin e oil or engine oil f ilter: 20 seconds 7. When the engine rotation sta bilizes, return to th e low idle (MIN) p osition o f fuel co ntrol d ial (1) a nd then c arry out Regardles s of the ambient te mperature, if the ke y in the starting switch (2) is turn ed fro m the OF F positio n to the ating pilot lamp (3) will light up and pre heating will start.

(Preheat ing continues while th e starting switch ld at the left.) of the preheating time, see the table During the preheating operati on, preheating pilo t lamp (3) lights up to sho w that p reheating is b eing carried out. If the engi minute in REMARK The turbo protect function is a function to protec t the turbocharger. It kee ps the engin e speed below 10 00 r pm for a set ti me after the engine is started even if t he pedal is fully depresse d. The basic function acts to ca ncel the actuation of the turbo protect functio n whe n the e ngine o il pressur e rises. The settin actuated, t gs for the maximu m actuation time a re as shown below.

Wh en the turbo he engine speed d oes not change ev en when the fue l control dial is o perated. Cooling water temperature Turbo protect time Above 10°C (50°F) 0 10 to -30°C (50 to -22°F) Change 0 to 2 below -30°C (-22°F) 20