. OPERATION OPERATION that the top of the the shank tilted change the ground before turning. over. 3 - 116 PRECAUTIONS WHEN RIPPING For th e digging an gle when rippin shank is perpendi cular, then lower the ripper Do no t carry out r ipping for l ong periods wi back. The tip of th e point will wea r to a roun Do no the direction of travel during the ripping will cause breakage of the shank. When ction of travel, remove the shanks from the ing. uring the r ipping Never drive in rev erse when the r ipper poin t is inserted in the bedroc k. The pin i nstalling th e poin t will brea k and the po int will fall off. Stop t he machine, tilt back slightly , then rais e the ripper slowly.
After r ipping, if th e broken r ock is compara tively large, avoid traveli ng over the r ipping path whe n traveling in reverse. When traveli large r ng in reverse ocks. As fa , check the rear r as possible, c carefully to hoose lev avoid heati el ground to ng any travel