Komatsu — ADJUSTING POSTURE OF WORK EQUIPMENT

. OPERATION OPERATION ADJUST ANGLE OF BLADE EDGE (Angledozer, power tiltdozer) WARNING 3 - 125 It is dangerous if the work equip ment moves by mistake when adjusting angle of the b lade edge. Set the wor stabl e condition , then stop the en gine and lock the work e quipment securely with the s afety lock lever. Adju st the ang le (θ) of the bla de edge to match the t ype of soil ANGLEDOZER ength of the left and right braces the same, change To m ake the l ength of the left and right braces the s distance ( l ) b etween the join ts and adjust the cutti ng angle. Adju st distanc e ( l ) between the joints as follows:

To I NCREAS E distance ( l ), INCREASE cutting an To D ECREAS E distance ( l ), DECREASE cutting a ngle (θ). The standard cutting angle (θ The standard distance ( l ) be tween the joints is 149 3 mm (4 ft 11 in). POWER TILTDOZER Turn the brac e with bar handl e (1) and the distance ( l ) between the j oints to ch ange the cuttin g angle (θ) as follows. INCREASE di stance ( l ) to IN CREASE angle (θ) DECREASE d istance ( l ) to DECREASE angle (θ). The standard cutting angle (θ The standard distance ( l ) bet ween the joints is 1389 mm(4ft 7 in).

Cutting angle θ Advantages Disadvantages Large Amount of soil spilled to rear of blade is small Separation of soil is good and little soil is carried back Soil digging resistance and rol resistance are large Load pushed by blade is small Small Soil digging resistance and rolling-up resistance are small Load pushed by blade is large Cutting amount on rough surfaces is good Amount of soil spilled to rear o large Separation of soil is poor and carried back