. OPERATION TROUBLESHOOTING TROUBLESHOOTING AFTER RUNNING OUT OF FUEL WARNING starting. NOTICE 3 - 139 When air bleed plu g (2) at the top of the f uel filter hea d or s upply pum p air breather (4) are removed, the system is still under pressure, so fuel m ay spurt out. Loosen t hese parts sl owly before opening them. When starting aft er running out of fue l, fill the filte r cartridge with fue l and bleed the air from t he fue l system b efore PROCEDURE FOR BLEEDING AI 1.
Remove the f uel filter cartridge, fil l the filter c ase with fu el, th en insta The common rai l type fuel injection sy stem used o n this machine c onsists of higher pre cision parts t han the conventional injection pump a nd nozzle. This means that problem s are more likely to o ccur when dust or dirt g ets in. For this reason , take even more care t han usual not to let dirt or dust get in durin g inspectio n or maintenance. If any dir t should be stuck to an y part, use fuel to wash it off completely.
If clean fuel is no t available, keep the fu el cartridge in position and b leed the a ir with the p riming pump leve r (4) NOTICE When filling with fuel, use clean fuel and be careful n ot to l et any dust dirt get in. Porti on (B) at the center is t he clean side , so b e particular careful not to let any dust or dirt get in. When adding fue l, always add from sma ll hole (A) at eight places on t dirty side.