. MAINTENANCE OUTLINES OF SERVICE 4 - 8 FILTERS Filters are extremely important safety parts. T important equipment and causing problems. Replace all filters periodically. For details, see t However, when working in severe conditions, r (sulfur content) being used. hey prevent impurities in the fuel and air circuits from entering he Operation and Maintenance Manual. Replace all filters periodically. For details, see t However, when working in severe conditions, r eplace the filters at shorter intervals according to the oil and fuel (sulfur content) being used. d use them again. Always replace with new filters.
Never try to clean the filters (cartridge type) an When replacing oil filters, check if any metal par ticles are affixed to the old filter. If any metal particles ar e found, contact your Komatsu distributor. ore they are to be used. Do not open packs of spare filters until just bef Always use Komatsu genuine filters. OUTLINE OF ELECTRIC SYSTEM It i s extremely dangerous if the electrical equipm ent becomes wet or the covering of the wiring is damag ed. This wil l cause electrical leakage and may lead to m alfunction of the machine. Inspection and maintenance works include che cking the fan belt for tension and damage as well as the battery for electrolyte level.
ponents installed in the machine. n those specified by Komatsu. ater when washing the machine or when it rains. the electric system to prevent corrosion. e fuse, ignition switch, battery relay, etc. Never remove or disassemble any electric com Never install any electric components other tha Be careful to keep the electric system free of w When working on the seashore, carefully clean Never connect any optional power source to th HANDLING HYDRAULIC RELATED EQU IPMENT During operations and after completion of oper ations, the hydraulic equipment is at a high temperature.
During operations, it is also under the high pressure, related equipment, be careful of the following p Stop the machine on flat ground, lower the operation so that there is no pressure on the Always stop the engine. Immediately after stopping operations, the pressure, so wait for the oil temperature to g Even after the temperature has gone dow loosening plugs, bolts, or hose connections release the internal pressure before removin When carrying out inspection and maintenan tank to remove the internal pressure. Inspection and maintenance works include ch elements and replacement of hydraulic oil.
operations, it is also under the high pressure, so when carrying out inspection and maintenance of hydraulic oints. work equipment completely to the ground, and carry out the cylinder circuits. hydraulic oil and lubricating oil is at high temperature and high o down before starting maintenance. n, some parts may still be under internal pressure, so when ydraulic related equipment, be careful of the following p Stop the machine on flat ground, lower the operation so that there is no pressure on the Always stop the engine.
Immediately after stopping operations, the pressure, so wait for the oil temperature to g Even after the temperature has gone dow loosening plugs, bolts, or hose connections , do not stand directly in front of the parts, and loosen slowly to g. to release the internal pressure before removin When carrying out inspection and maintenan ce of the hydraulic circuit, always release the air in the h ydraulic ecking the hydraulic system for oil level, replacement of filter If h igh-pressurehoses have been removed, che ck that there is no damage to the O-rings. If any damage i s found, replace the O-ring.
It i s necessary to bleed the air from the circuits when the hydraulic filter element or strainer have been r eplaced or washed, or when hydraulic equipment has b een repaired or replaced, or when the hydraulic piping h as been removed. The accumulator is charged with high-pressu re nitrogen gas, and it is extremely dangerous if it is handled g, see "ACCUMULATOR, HANDLING (PAGE 3-66)". Th e handled incorrectly. For details of the method of handlin