. MAINTENANCE SERVICE PROCEDURE REPLACE CORROSION RESISTOR CARTRIDGE WARNING The oil is at high temperature after the engine has been operated, so never replace the cartridge immediately after finishing 4 - 63 operations. Wait for the oil t o cool down before replacing Container t Filter wrenc 1. Close lev er (1) of corrosion resistor ( 2). (2 pla 2. Set a cont ainer under the c artridge to catch th 3. Using a fil ter wrench, turn c artridge ( 2) to the l eft to remo ve it. 4. Clean the filter holder, co at the s eal surfa new hinly with engine oil, then i nstall the use a genuine Ko matsu p art for the 5.
When inst alling the cartridge , bring th e packing surface int o contact with the seal surface of the filter holder, then tighten a f If the filter will leak fr urther 2/3 times. cartridge is tighte ned too f ar, the ga sket will be damage d and water will leak. If it is too loose, water om the gap in the gasket, s o always keep to th e proper 6. Open leve r (1) of corrosion resistor ( 7. After repla cing the cartridge , run the engine, a nd check fo r any leakage of water from t he filter seal surface. If any water leakage is found, check th e tighteni ng of the fil ter cartridge.