. OPERATION EXPLANATION OF COMPONENTS METHOD OF USING MAINTENANCE MODE operating the The item marked * is displayed in the above table, but is not used on this machine. When the oil or filter has been replaced, select the applicable item, then operate the buzzer cancel switch to ‘ . The screen will ask if you want to display the replacement history. Operate the information switch to select YES, then operate the buzzer cancel switch to ‘ . The replacement account will increase by 1, the replacement interval will be reset, and the oil, filter change interval lamp will go out.
When this is done, if the maintenance caution lamp does not go out, there is another item close to the replacement time, so check the situation. 3 - 24 NOTICE This function i s only a guidelin e. If dirty oil or fi lters a re found during daily m aintenance, replace them immediately. If the controller s or mon itor pan el are replaced, t he timer for this function will n ot w orl properly. Contact your K omats u distributor for re placemen t. The maintenance mo de sho ws the replacement interval fo r the oil filter s and oil on the monitor The content of the di splay is as follows (1) T (2) T he he item i time r s displayed. emaining until (3) T n he ow number of ti is displayed.
The display items c an be displayed in order b information s witch to the left or right ( >). Display Item 1st replacement interval 2nd and following replacement intervals 1. ENG.OIL Engine oil 500h 500h 2. ENG.FILT Engine oil filter 500h 500h FUEL.FILT Fuel filter 500h HYD.FILT Hydraulic oil filter 500h CORR.RES Corrosion resistor 1000h 6. BYPS.FILT Bypass filter (*) 0h 0h 7. DAMP.OIL Damper oil 2000h 2000h 8. FNL.OIL Final drive oil 500h 1000h 9. HYD.OIL Hydraulic oil 500h 2000h 10. POWL.OIL Power train oil 500h 1000h 11. POWL.FILT Power train oil filter 500h 500h 12. HSS.FILT HSS charge filter 250h 1000h