Komatsu — CONTROL LEVERS, PEDALS

. OPERATION EXPLANATION OF COMPONENTS RIPPER CONTROL LEVER 3 - 41 Thi s lever ( 8) is used to operate the (a) RAISE (b) HOLD: Ripper stops and stays in same position (c) LOWER (A) Digging angle reduced: Cutting angle (α ) becomes smaller. (B) Digging angle increased : Cutting angle (α) becomes larger. PIN PULLER CONTROL SWITCH Switch (9) i s used to operat e the pin puller. (a) Pull out: Pin is pulled ou t (b) Push in: Pin is pushed in