Deutz — 4.6.1 CHECKING CALIBRATION OF THE SUSPENSION POSITION SENSOR

4. PUTTING THE TRACTOR INTO SERVICE 4.6 RENEWAL OF AXLE SUSPENSION CONTROL UNIT 4.6 RENEWAL OF AXLE SUSPENSION CONTROL UNIT Whenever the front axle suspension control unit is renewed, the technician must verify that the axle suspension position sensor is correctly deployed. The purpose of this verification is to inform the control unit of the voltage values generated by the sensor when the sus- pension is inactive, or at rest. To perform the verification, connect the ART to the connector in the control units compartment of the cab, select axle sus- pension from the “AVAILABLE TESTS” menu and proceed as described.

4.6.1 CHECKING CALIBRATION OF THE SUSPENSION POSITION SENSOR NOTE This operation must be carried out with the engine running on idle, the parking brake applied, the shuttle lever in neutral and the axle suspension deactivated . 1 - From the main menu, press “ 1 ” to bring up the MONITORS MENU 2 - Press “ 1 3 - Verify that the voltage output signal from the axle suspension position sensor (indicated under the item “ POSI ” is 1.9 V. 4 - In the event of the value being incorrect, proceed with calibration of the sensor as described in the chapter “REMOVAL AND POSITIONING OF THE FRONT AXLE SUSPENSION POSITION SENSOR”, section 30.

5 - Activate the axle suspension and check that the voltage output signal from the position sensor (indicated under the item “ POSI ” is approximately 3.8 V). 20-41 M o n i t o r M e n u - - - - - - - - - - - - - - - - 1 - S U S P E N S I O N 2 - P o w e r S u p p l y [ E ] E x i t S u s p e n s i o n - - - - - - - - - - - - - - - - S t a t u s L O C K M i n - - - P o s . - - - M a x 2 . 0 V 1 . 9 V 6 . 0 V L S S V 0 m A O F F U P S V 0 m A O F F D W S V 0 m A O F F B r a k e O F F 4 W h e e l D r i v e O F F W h e e l s K m / h 0 . 0 [ E ] E x i t