5. ALARMS 5.1 LIFT AND ASM CONTROL UNIT ALARMS 5. ALARMS This chapter contains a list of all the alarms that can be detected by the tractor's electronic system. To facilitate searches, the alarms are organized according to the control unit by which they are detected: 1 - List of alarms displayed by the hydraulic lift and ASM control unit. For details of how the alarms are displayed, see the heading “Power lift control unit”. 2 - List of alarms displayed on EDS: list of alarms detected by transmission control unit. For details of how the alarms are displayed, see the heading “Transmission control unit”. 3 - List of alarms displayed on SERDIA: list of alarms detected by engine control unit.
For details of how the alarms are displayed, see the heading “Engine control unit (DEUTZ EMR2)”. 4 - List of alarms displayed by the front axle suspension control unit. For details of how the alarms are displayed, see the heading Front axle suspension control unit. 5.1 LIFT AND ASM CONTROL UNIT ALARMS The hydraulic lift control unit warns the operator of any malfunction in monitored components by way of a red Led (lift trans- port lock indicator) located on the lift control console.
Faults are indicated using a system of coded flash sequences which, depending on how the control unit has been con- figured, will either specify the precise nature of the fault (extended alarm) or simply identify the device affected (standard alarm). Also, and likewise depending on the configuration, the unit can display only the alarm with the lowest code (rotation of de- activated alarms),or it can display all the active alarms (rotation of alarms activated), whereas the ART shows the 10 most recent alarms generated, and if a further alarm is triggered, the first of the ten will be eliminated.
To verify, using the ART, whether or not an alarm detected is “active”, the technician must cancel all the alarms, turn the starter key to the “ O ” (OFF) position, then make a fresh connection to the control unit. CAUTION In the event of it no longer being possible to operate the lift, and alarm 11 is indicated, check whether or not the ART will connect to the control unit. If a connection cannot be made, the problem is identifiable as a fault affecting the EPROM, which must therefore be replaced. 20-43