5. ALARMS 5.2 LIST OF TRANSMISSION CONTROL UNIT ALARMS ALARM N° 21 DESCRIPTION The control unit detects a ground speed higher than the permissible limit ECU RESPONSE The control unit does not limit the operation of the transmission, but sounds a continuous beep until ground speed returns within the permissible limits. CHECK Reduce ground speed. ALARM N° 22 DESCRIPTION The control unit detects a transmission oil temperature higher than the permissible limit with the machine operating in “FIELD” mode.
ECU RESPONSE The control unit does not limit the operation of the transmission, but when the alarm is activated, five beeps will be sounded in succession, and a single beep every two minutes thereafter. CHECK Reduce the load on the transmission. Switch off the engine. ALARM N° 23 DESCRIPTION The control unit detects a transmission oil temperature higher than the permissible limit with the machine operating in “ROAD” mode. ECU RESPONSE The control unit does not limit the operation of the transmission, and does not display any alarm message.
CHECK Reduce ground speed fault code is not shown on the display temperature monitoring only if configured counter increments, if over temperature is pending (mark for duration) fault code erasable only with a special diagnostic service tool (security fault memory) 20-94