5. ALARMS 5.2 LIST OF TRANSMISSION CONTROL UNIT ALARMS ALARM N° 36 DESCRIPTION The control unit detects that solenoid Y4 is either not connected or faulty. ECU RESPONSE The control unit limits operation to "STAND-BY STRATEGY” mode. CHECK Check that the contacts on connector “EV GROUP” and connector “ECU PS” of the transmission control unit are firmly attached and not oxidised. With the starter key in the “O” (OFF) position, connect a test meter to pin E and pin F of connector “EV GROUP” on the transmission, and measure the resistance of the solenoid (for details, see section 40).
With the starter key in the “O” (OFF) position, connect a test meter to pin E of connector “EV GROUP” and pin 11 of con- nector “ECU PS”, and measure the resistance to verify the continuity of the circuit (meter reading: 0 Ohm). Clear all alarms, turn the starter key first to “O” (OFF) and then back to the “I” (ON) position again, and if the alarm is still present, the control unit must be renewed. 20-96 0.012.8732.4 1 2 8 32 11 13 21 23 45 55 57 68 2145 23 68 1 2 11 8 57 32 13 55 ECU PS GND4 J2 TKAB1 3 6 F35 F27 7.5A 7.5A +15 +30 0441.9533 5 1 6 17 21 16 E F C D A B EV GROUP Y4 Y2 Y3 Y1 0.012.8672.4 D0017281 21 45 23 68 1 2 11 8 57 32 13 5 GND4 J2 3 6 17 21 1 C D A B