5. ALARMS 5.2 LIST OF TRANSMISSION CONTROL UNIT ALARMS ALARM N° 48 DESCRIPTION The control unit detects that the rpm sensor nAb is short-circuiting to earth ECU RESPONSE The control unit limits operation to “LIMP-HOME” mode, and at the first attempt to shuttle in either direction, the trans- mission will revert to neutral, emitting a continuous beep. CHECK Check that the contacts on connector “NAB” and on connector “ECU PS” of the transmission control unit are firmly at- tached and not oxidised.
With the starter key in the “O” (OFF) position, connect a test meter to pin 2 of connector “NHK” and to transmission earth, and measure the resistance to verify that there are no short circuits to earth (meter reading: infinity). Verify the correct operation of the sensor (for technical details, see section 40). Clear all alarms, turn the starter key first to “O” (OFF) and then back to the “I” (ON) position again, and if the alarm is still present, the control unit must be renewed. 20-103 0.012.8732.4 1 2 3 16 21 23 45 68 2145 23 68 1 2 16 3 ECU PS GND4 J2 TKAB1 3 6 F35 F27 7.5A 7.5A +15 +30 0441.9533 11 12 13 NAB 3 2 1 0.012.8672.4 D0017361 21 45 23 68 1 2 16 GND4 J2 J2 3 1 1 2 1 3 2