5. ALARMS 5.2 LIST OF TRANSMISSION CONTROL UNIT ALARMS ALARM N° 67 DESCRIPTION The control unit detects that the power input to the clutch pedal position sensor is lower than the correct value ECU RESPONSE The control unit limits operation to “EMERGENCY DRIVE” mode, the transmission reverts to neutral and a continuous beep is sounded. In the event that one or more of alarms 85, 92 and 93 should also be activated, the transmission will be switched to “TC-SHUTDOWN” mode. NOTE This alarm could be displayed as a result of alarm 69 being activated.
CHECK In the event that there are other alarms activated, relating to the clutch pedal position sensor or the transmission oil tem- perature sensor, verify the cause as described under the relative alarm headings before proceeding as follows. Check that the contacts on connector “X34” of the clutch pedal position sensor, connector “TEMP” of the transmission oil temperature sensor, and connector “ECU PS” of the transmission control unit, are all firmly attached and not ox- idised. With the starter key in the “I” (ON) position, check that the power input to the clutch pedal position sensor is correct (5V measured between pin 2 (positive) and pin 1 (negative) of connector “X34”).
Verify the correct operation of the sensor (for technical details, see section 40). Clear all alarms, turn the starter key first to “O” (OFF) and then back to the “I” (ON) position again, and if the alarm is still present, the control unit must be renewed. 20-117 0.012.8732.4 1 2 21 23 45 24 37 38 39 68 2145 23 68 1 2 38 3724 39 ECU PS GND4 J2 AS6 TKAB1 3 6 F35 F27 7.5A 7.5A +15 +30 0441.9533 3 2 1 X34 4 1 2 0.012.8894.4 10 20 TEMP 2 1 0.012.8672.4 D0017441 21 45 23 68 1 2 38 37 24 GND4 J2 3 3 2 1 4 1 2 1 0 2 0 2 1