Deutz — 5.2.4 ANALYSIS OF ALARMS

5. ALARMS 5.2 LIST OF TRANSMISSION CONTROL UNIT ALARMS ALARM N° 69 DESCRIPTION The control unit detects one or more threshold values of the clutch pedal position sensor out of range. ECU RESPONSE The control unit limits operation to “EMERGENCY DRIVE” mode, the transmission reverts to neutral and a continuous beep is sounded. In the event that one or more of alarms 85, 92 and 93 should also be activated, the transmission will be switched to “TC-SHUTDOWN” mode. CHECK Perform the clutch pedal sensor calibration procedure. Clear all alarms, turn the starter key first to “O” (OFF) and then back to the “I” (ON) position again, and if the alarm is still present, the control unit must be renewed.

ALARM N° 70 DESCRIPTION The control unit detects that the calibration values of the clutch pedal have not been saved correctly due to a defect in the EEPROM memory locations, or that the clutch pedal has never been calibrated ECU RESPONSE The control unit limits operation to “EMERGENCY DRIVE” mode, the transmission reverts to neutral and a continuous beep is sounded. In the event that one or more of alarms 85, 92 and 93 should also be activated, the transmission will be switched to “TC-SHUTDOWN” mode. NOTE This alarm could be displayed as a result of alarm 64 being activated. CHECK Perform the clutch pedal sensor calibration procedure.

Clear all alarms, turn the starter key first to “O” (OFF) and then back to the “I” (ON) position again, and if the alarm is still present, the control unit must be renewed. 20-119